====== Cura 15.04 ======

Cura is the advised software for preparing your 3D print files. Cura will help you converting 3D models into 3D print files within a couple of seconds and shows you a preview of the print in order to ensure everything is as you would like it to be.

----

===== Getting started =====

  - [[https://ultimaker.com/en/support/view/16579-installation|Installation]]
  - [[https://ultimaker.com/en/support/view/16580-configuration|Configuration]]
  - [[https://ultimaker.com/en/support/view/16581-interface|Interface]]

----

===== The basics =====

  - [[https://ultimaker.com/en/support/view/16582-preparing-a-print-file|Preparing a print file]]
  - [[https://ultimaker.com/en/support/view/16583-adjusting-the-model|Adjusting the model]]
  - [[https://ultimaker.com/en/support/view/16584-view-modes|View modes]]
  - [[https://ultimaker.com/en/support/view/16585-updating-firmware|Updating firmware]]

----

===== Full settings =====

  - [[https://ultimaker.com/en/support/view/16586-basic|Basic]]
  - [[https://ultimaker.com/en/support/view/16588-expert-settings|Expert Settings]]
  - [[https://ultimaker.com/en/support/view/16589-plugins|Plugins]]
  - [[https://ultimaker.com/en/support/view/16587-advanced|Advanced]]